SIGLENT
SPD3000X QuickStart 17
2.7 Save and Recall
Five group setups can be saved in memory. The contents of the setup file
including:
Independent/series/parallel mode
Output voltage/current value
Timer setup
Save setup
Operation steps:
1. Set the state that you wanted;
2. Short press “IP/Store” button and then long press “IP/Store” button to enter
Store/Recall interface;
3. Press direction button to move the cursor to “FILE CHOICE”
4. Select file store position(FILE1~FILE5) by revolving the multi-function
knob;
5. Press direction button to move the cursor to “OPER CHOICE”;
6. Move the cursor to “STORE” by revolving the multi-function knob, and then
press it to save the current setup.
Recall setup
Operation steps:
1. Short press “IP/Store” button and then long press “IP/Store” button to enter
Store/Recall interface;
2. Press direction button to move the cursor to “FILE CHOICE”
3. Select the wanted file by revolving the multi-function knob;
4. Press direction button to move the cursor to “OPER CHOICE”;
5. Move the cursor to “RECALL” by revolving the multi-function knob, and
then press it to save the current setup.
Note: if you want to delete the file that has been saved, please go on with
step 3 above, select “DELETE” and then press it.
To Next Page
Loading...
