SIGLENT
18 SPD3000X QuickStart
2.8 Timer
The timer works in the Independent mode, and can save five timing setups,
each of which is independent from each other. You can set any voltage/current
value within the range as you want. The timer supports consecutive output,
and the longest time of each group is 10000s.
Setup timer
Operation steps:
1. Press “TIMER” to enter the Timer Setup interface, and the indicator light
turns bright immediately;
2. Press “1”/”2” button to select the wanted channel;
3. Move the cursor to select the wanted parameter(voltage/current/time) by
pressing the direction button;
4. Set the corresponding value through “Fine” button and .multi-function knob
5. Press “Timer” again to exit current interface.
To Next Page
Loading...
