Page 20 User Manual APOLLO
ARMING:
Enter [USER CODE] and press [PART]. On the Display you will
see the letter [Α] (Arm). Press key [1] to arm the 1
st
partition, [2] to arm
the 2
nd
partition, or both [1] & [2] to arm both partitions. By pressing the
keys [1], [2] the LED’s 1 and 2 will turn on or off as an indication of the
partitions that will arm. Press [ENTER]. The LED “ARM” will change
status and the exit delay will start count down.
NOTE: Using the above mentioned method you can only fully
arm the system. You can not HOME arm both partitions, by this
method.
DISARMING:
Enter the premices via an entrance that belongs to a delay zone. The
buzzer will sound to indicate you must disarm the system. Enter [USER
CODE] and press [PART]. On the Display you will see the letter [d]
(disarm). Press key [1] to disarm the 1st partition, [2] to disarm the 2nd
partition, or both [1] & [2] to disarm both partitions. Press [ENTER]. The
LED “ARM” will change.
In both cases, you have the ability to change from arming to
disarming and the opposite, by pressing the key [PART].
CANCEL THE ALARM IN CASE OF 2 PARTITIONS
When the control panel operates in 2 partitions you may cancel an
alarm using the following methods:
1. From a keypad of the partition in alarm, enter [USER CODE]
and press [ENTER]. The system will be disarmed and the sirens
will silence. The digital communicator will report to the Central
Station.
2. From a keypad that belongs to the other partition, you may
silence the sirens without disarming the system entering [USER
CODE] and press [ENTER]. The digital communicator will
report to the Central Station.
If the alarm was triggered by a fire zone, the siren sounds
intermittently, and on the keypads the relative zone LED turns on. The
To Next Page
Loading...