SA300 Installation Instructions
2 YEAR (24 MONTHS) LIMITED WARRANTY FROM MANUFACTURED DATE – VOID IF ANY REPAIR OR
MODIFICATION IS ATTEMPTED TO MOTOR, MECHANISM, ELECTRONICS OR CONTROL ASSEMBLY
AND/OR IF IMPROPERLY INSTALLED.
WARNING
Failure to follow the instructions and information in this manual may result in personal injury or damage to
equipment. SIGMA AUTOMATICS will not be held responsible for any loss, damage or injury if instructions and proper
precautions are not followed. To reduce the risk of injury or damage - use this operator with single or double pedestrian
swinging doors only. Save these instructions for future reference.
AVOID ELECTRICAL SHOCK, INJURY, MALFUNCTIONS OR FIRE!
ADJUSTMENTS/INSTALLATION/MAINTENACE TO BE PERFORMED BY QUALIFIED OR TRAINED
PERSONNEL ONLY.
PLEASE READ ALL INSTRUCTIONS BEFORE INSTALLATION.
AVOID ELECTRICAL SHOCK. DISCONNECT POWER DURING INSTALLATION OR MAINTENANCE.
POWER REQUIRED 120VAC, 1A.
CONTROL BOARD POWER SUPPLY 24VDC.
ENSURE CONTROL BOARD AND OPERATOR ARE GROUNDED.
FOLLOW ALL LOCAL WIRING REGULATIONS OR STANDARDS.
KEEP FINGERS AND CLOTHING CLEAR OF ALL MOVING PARTS.
ALTERATION TO ANY COMPONENTS IS PROHIBITED AND WILL VOID WARRANTY.
BEFORE POWERING ON, REMOVE ANY MECHANICAL DEVICES OR LOCKS THAT INTERFERE WITH THE
OPERATION OF THE DOOR (OTHER THAN PARTS INTEGRATED WITH THE OPERATOR SYSTEM).
OPERATOR TO BE INSTALLED 8 FEET MINIMUM ABOVE GROUND IF THERE ARE ANY EXPOSED
MOVING PARTS.
OPERATOR HOUSING IS NOT WEATHER PROOF OR SEALED. EXCESSIVE MOISTURE OR CORRISIVE
ENVIRONMENTS MAY DAMAGE ELECTRONIC COMPONENTS.
OPERATOR SHALL NOT CLOSE WITH A FORCE GREATER THAN 30 LBF (133.4 N) AT THE LATCH SIDE OF
THE CLOSING STILE, AND SHALL NOT CLOSE THROUGH THE FINAL 10 DEGREES IN LESS THAN 1.5
SECONDS.
SERIOUS INJURY MAY OCCUR IF THE POWER CORD IS CAUGHT OR PINCHED IN ANY OF THE MOVING
COMPONENTS OF THE OPERATOR, DOOR OR SYSTEM.
SERIOUS INJURY MAY OCCUR IF THE HEADER UNIT IS NOT PROPERLY SECURED TO A SOLID
STRUCTURAL SURFACE AND/OR IF COMPONENTS ARE NOT SECURELY FIXED TO THE HEADER UNIT.
To Next Page
Loading...