SA300 Installation Instructions
11.
Appendix 2: Safety Check List
This checklist is provided to help ensure pedestrian safety and the proper operation of the door operator. These
safety checks are repeated on the AAADM sticker applied to the door frame.
•
Verify that the power switch on the device header is switched to ON and that the device is properly
powered.
•
Activate the door operator
o
Door should open at a slow and even pace (4 or more seconds) and stop without impact.
o
Door must remain fully open for a minimum of 5 seconds before beginning to close.
o
Door should close at a slow and even pace (4 or more seconds) and stop without impact.
•
Inspect the floor area. It should be clean with no loose objects or uneven surfaces that may cause a
pedestrian to trip or fall. Keep traffic path clear.
•
Inspect the doors over all condition. Safety signage should be present and visible and hardware should be
in good condition.
•
Inspect the door operator for damage, excessive wear or weathering. Header cover and arms should be
properly secured.
•
Have the door operator inspected by an AAADM certified inspector on a yearly basis.
•
Follow any and all maintenance requirements for all safety sensors, activation buttons, card readers and
keypads.
DO NOT USE DOOR OPERATOR if it fails any of the safety checks listed above or if it malfunctions in any way.
Call a qualified automatic door service company to have the operator repaired or serviced.
To Previous Page