SA300 Installation Instructions
3.
Safety Information
This document contains important instructions for installation of the SA 300 swing door operators. Review these
instructions thoroughly prior to installation and follow them carefully during installation, commissioning,
troubleshooting and maintenance.
3.1. Safety Warnings
•
Damage to equipment or incorrect equipment operation may result from an incorrect installation.
•
Hazard to mechanical processes by use of control settings elements or procedures not documented in this
manual!
•
Electric shock hazard!
•
By use of control elements, settings of Procedures not documented in this manual!
•
Work on electrical equipment and 120VAC wiring installation must be performed only by qualified or
trained personnel!
•
Metallic doors must be grounded per national and local codes!
•
Hand pinch point and crushing hazards of door closing edges!
•
Crushing hazards at door closing edges!
•
Prior to mounting the SA 300 check that proper power has been delivered to the location in accordance
with local electrical code
•
Ensure that the high-power cables (e.g., 120 vac) do not share the access hole as the low voltage wires
3.2. Post Installation Hazards
•
After installation, hazards such as minor crushing, impact with limited force, and risk to unsupervised
children may exist depending on structural design of door area, type of door, and any safeguards that
have been implemented.
•
Hand pinch point and crushing hazards at arm and track
To Next Page
Loading...