Instruction, use and maintenance manual Pag. 8/39 BMR 20-20H-30 Planetary Mixer
5. Customer set-ups
The environmental conditions of the location where the machine is installed must have the following features:
• Humidity-free.
• Water and heat sources at an appropriate distance.
• Appropriate ventilation and lighting that is compliant with the hygiene and safety standards required by the laws
in force. The floor must be level and compact in order to favour proper cleaning.
• There must be no obstacles in the immediate vicinity of the machine that might compromise normal ventilation
and operation of the machine in question.
• Upon machine arrival, make sure it is intact. Should it not be possible to immediately check the machinery,
accept subject to verification. Any damages incurred during transport or delivery must be immediately reported.
• Make sure that the room voltage is the same of the machine: check the label near the power supply cable.
Connection to the line MUST be done via a CE standard blocked socket, fitted with three valves adequate to
the amount of current absorbed during machine operation.
The electrical mains must have an automatic circuit breaker with adequate features to those of the
machine, where the opening distance between contacts is at least 3 mm. In particular, an earthing
system compliant with current regulations is essential.
5.1. Instructions for ordering spare parts
SIGMA S.r.l., reserves to make all changes it deems necessary to its machine models.
It is, therefore, always necessary to specify:
• Machine type
• Year of manufacture
• Position
• Description
• Serial no.
• Desired amount of requested pieces.
Address your request to:
Sigma S.r.l.
via Artigianato 85,
25030 Torbole Casaglia (BS) Italy
Tel 030 265 04 88 - Fax 030 265 01 43
www.sigmasrl.info - Email: info@sigmasrl.info
Check that the system power supply voltage and frequency are compatible with the
values indicated in the technical features and on the plate affixed to the machine.
To Next Page
Loading...
