Instruction, use and maintenance manual Pag. 9/39 BMR 20-20H-30 Planetary Mixer
6. Safe work methods and procedures
In order to prevent hazardous conditions and/or possible injuries caused by: electric current, mechanical parts, fire,
or of hygienic nature, the following safety warnings must be observed:
• Keep your work station tidy. Untidiness may cause accidents.
• Assess the environmental conditions. Not in a damp, wet or insufficiently lit environment, near flammable
liquids or gas.
• Keep children and unauthorised people away. Do not allow them to approach the machine or the work station.
• Use the machine within the powers on the plate and for the intended use only. It will work better and safer
without overload.
• Dress adequately. Do not wear dangling clothes or accessories that may get entangled in moving parts. Use
non-slip shoes. For health and safety reasons, long hair should be gathered in an appropriate net and gloves
should be worn.
• Protect the power supply cable. Do not pull the cable to disconnect the plug. Do not expose the cable to high
temperatures, in contact with sharp edges, water or solvents.
• Avoid unsafe positions. Find the most appropriate position that always ensures balance.
• Always pay the utmost attention.
• After each machine use and before cleaning, maintenance or displacement, disconnect the plug from the
socket.
• Do not use extension cables outdoors.
• Check that the machine is not damaged. Carefully check the effectiveness of the safety devices before using
the machine. Check that: mobile parts are fixed, that there are no damaged components, that all parts are
properly assembled and that all conditions which may affect the regular operation of the machine are optimal.
• Have the machine repaired by qualified personnel. Repairs must only be performed by qualified personnel
using original spare parts.
FAILURE TO OBSERVE THESE REQUIREMENTS MAY BE CAUSE OF HAZARD FOR THE USER.
6.1. Risks for the operator
Risk of injury: from the chute or disassembling the casings during maintenance, you can access the
moving parts of the machine.
Hazardous areas are where serious injuries may occur, do not introduce limbs or other objects
without having secured the machine.
Electrocution hazard: the machine must not be used without adequate earthing, and it must be
connected to a system built according to building regulations in force in the country of installation.
READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THE MACHINE
To Next Page
Loading...
