To Next Page

To Previous Page

WARNINGS/PRECAUTIONS

Operation On Optical Fiber Fusion Splicer

When Below Situation Happens On Fusion Splicer, Please Turn Off The Fusion Splicer Immediately And

Unplug The Power Adapter From The Power Input, Otherwise It Will Cause The Fusion Splicer May Not

Work Properly Or Can Not Be Repaired And Other Serious Consequences.

》Liquid, foreign matter into the inside of the fiber fusion splicer. There is a protective structure inside the

machine. A small amount of fiber debris will not affect the use, but please try to be careful not to fall in.

》fiber fusion splicer is subjected to strong vibration and impact

There is no need to maintain the fiber fusion splicer internal parts, do not remove the fiber fusion splicer.

In the electrode discharge process of fiber fusion splicer, the voltage between the two electrode rod is up to

several dry volts, do not touch the electrode, otherwise will cause the fiber fusion splicer damage or personal

injury and other serious consequences.

storage (storage time less than or equal to 6 months) is: -20℃~60℃.

4.In order to ensure the safety of charging, the charging temperature range of lithium battery inside the welding machine

is O℃~ 40℃.

5.If the battery charging is abnormal or the battery display is abnormal, you can try to activate the battery manually.

For specific operation, please see: button combination function -- three to activate the battery

Notice:

1.Optical fiber fusion splicer is used for welding quartz glass fiber, please do not use this instrument for other purposes.

Please read this manual carefully before use.

2.Pay attention to clean the V groove and lens in the process of use (to clean V groove,you can use an art knife to

draw back and forth along the fiber groove, and then brush with a brush); Clean dust after use.

3.When the optical fiber fusion splicer moves from the low temperature environment to the high temperature environment,

try to take the gradual heating mode, otherwise the instrument will produce condensation, which has an adverse impact

on the instrument.

4.optical fiber fusion splicer is a calibrated precision instrument, please try to avoid strong vibration and impact. Special

carry case should be used for storage, and suitable cushioning case should be added outside the carry case for long-

distance transportation.

LCD display screen

1.The LCD screen of fiber fusion splicer is not touch screen.Do not use sharp objects to click on the LCD, do not force

the LCD.

2.Do not drop organic solvents or dirty sundries on the LCD screen, such as acetone, oil, antifreeze, ointment, etc.,

otherwise it may lead to abnormal LCD display.

3.Can use silken cloth or soft fabric to wipe clean liquid crystal screen.

4.There may be noise on the screen when the fusing machine windproof cover is opened or not put in the optical fiber.

These are not LCD fault, is a normal phenomenon

SIGNAL FIRE AI-9 User Manual

Other manuals for SIGNAL FIRE AI-9