DISPLAY MENU INTRODUCTION
09
INTRODUCTION TO SPLICE INTERFACE
10
Normal
mode
Normal Splicing Mode For The Machine
Splicing
process
pause
When the function is on,the splicing machine will stop the final splicing process after in
the completion of the fiber focus, end face detection and fiber alignment. Please then
press the “Continue “button to perform the arc discharge and the subsequent splicing process.
If the cleave face detection is not passed, it will pause and report the error, then
please press the “continue ” key to ignore the error and continue the follow-up process
Auto focus
When the function is turned on, for each time splicing it will adjust the camera focal length to the set target
value automatically (target value in the "Splicing settings"menu set"focus target value")
ARC
calibration
According to the altitude, temperature, humidity and other conditions of the user, match the most suitable
arc discharge value to minimize the splIcIng lOSS.(See chapter 4, discharge correction)
Smart lock
purpose
To Facilitate Management Or Owner's Effective Management Of The Splicer Machine's Use Period Or
The Number Of Splicing. Typical Applications Such As Rental Business
Optical power display area
X screen display
Fiber mode
Left end face angle
Splice status remind
Heating time
Y screen display
Bluetooth
Splicing loss
Right end face angle
Number of electrodes
remain
Total splicing
Smart tips
Camera failure Core align
failed
Focus failed ARC calibration
failed
Left and right
fiber does not
match
The lens is foggy
or foreign body
interference
Continue
Press "continue" To Continue The Splicing Process
ICON
NAME
FUNCTION
To Next Page
Loading...
Need help?
General