15
AFTER SALES SUPPORT
1300 777 137
service@unclebills.com.au
MODEL: EA2306 PRODUCT CODE: 713007 08/2023
Pairing your Bluetooth
®
Enabled Device
1. When connecting the headset to your Smartphone, MP3 player or GPS
navigation system; ensure the headset is turned off before connecting
via Bluetooth
®
.
2. With the headset in place and on your ears, press and hold the power/
intercom button for approximately 8 seconds until the LED indicator is
ashing (blue and red) and the headset voice prompt says 'pairing'.
3. Switch on the Bluetooth
®
functionality on your Bluetooth
®
device and
scan for available connections. The Motorcycle Bluetooth
®
Kit will be
shown in the available connections as ‘EA2306’.
4. When the device discovers ‘EA2306’, select and connect to ‘EA2306’.
This process should take a few seconds to connect, enter the password
‘0000’ if required.
5. When the headset and the Bluetooth
®
enabled device have paired,
the headset voice prompt will say 'connected'. At this stage, the LED
indicator will start ashing (blue) at slower intervals.
6. You are now ready to listen to music or make and receive calls from
your Bluetooth
®
enabled device.
NOTE: When using the Bluetooth
®
connection, always be aware that you
may need to adjust the volume on both the headset and the connected
device to reach the desired volume level. Please see the table on page 24
for instructions on how to adjust the volume via the headset.
Disconnecting the Bluetooth
®
Enabled Device
To end the connection between the Bluetooth
®
enabled device and the
headset, follow the steps below.
1. Ensure the headset is turned on (see instructions on page 14) and the
LED indicator is ashing blue.
2. Press and hold the power/intercom button for up to 8 seconds until you
hear a hang up tone. The Bluetooth
®
connection with the Bluetooth
®
enabled device has permanently ended.
Instructions (cont.)
To Next Page
Loading...