SIGNIFY EA2306 - Digital Assistant Ready

AFTER SALES SUPPORT
1300 777 137
service@unclebills.com.au
MODEL: EA2306 PRODUCT CODE: 713007 08/2023
16
Instructions (cont.)
NOTE: After pressing and holding the power/intercom button for
approximately 3 seconds the voice prompt will say 'power off'. At this
stage your headset has switched off but the Bluetooth
®
connection
with your Bluetooth
®
device has not permanently ended yet. Continue
to press and hold the power/intercom button for another 5 seconds
(i.e., total time of about 8 seconds) for the Bluetooth
®
connection to
permanently end with your Bluetooth
®
device.
3. To connect a new Bluetooth
®
enabled device, see pages 14-15 for
instructions.
NOTE: To disconnect the headset from your current Bluetooth
®
enabled
device, open the Bluetooth
®
settings of your Smartphone, MP3 player or GPS
navigation system and disconnect the ‘EA2306' Bluetooth
®
connection.
Digital Assistant Ready
The Signify
®
Motorcycle Bluetooth
®
Kit supports
voice-based digital assistants commonly found in
smartphones, tablets, and other Bluetooth
®
devices.
1. Ensure that the headset and your Bluetooth
®
enabled device are both
turned on and paired together (see instructions on pages 14-15).
2. Ensure that the voice-based digital assistant of your device is turned
on (follow instructions provided by the manufacturer of the Bluetooth
®
enabled device to activate the voice-based digital assistant).
3. Next, to interact with the voice-based digital assistant, press and hold the
multifunction button on the headset for approximately 2 seconds. Once
the headset voice prompts ‘Voice Dial', you can proceed with giving a
voice command to the voice-based digital assistant.
Alternatively, after step 2, you can also use a wake word or group of
words such as “Hey Siri” or “Hey Google” or other (based on the ecosystem
supported by your Bluetooth
®
enabled device) to start interacting directly
with the voice-based digital assistant.