SIGNIFY EA2306 - Switching the Headset Language; Resetting the Headset

23
AFTER SALES SUPPORT
1300 777 137
service@unclebills.com.au
MODEL: EA2306 PRODUCT CODE: 713007 08/2023
Instructions (cont.)
Switching the Headset Language
The headset supports a couple of different languages, English (default) and
Chinese. To switch languages, follow the steps below.
1. Ensure the headset is turned on (see instructions on page 14) and the
LED indicator is ashing.
2. Short press the power/intercom and multifunction buttons
simultaneously. The LED indicator should ash, and you should hear
a message in the other language. At this stage the language switch is
conrmed.
3. To revert to the previous language, follow step 2 again.
Resetting the Headset
To erase all of your settings and start fresh, the headset can be restored to
factory default settings by following the steps below.
1. Ensure the headset is turned on (see instructions on page 14) and the
LED indicator is ashing.
2. Press and hold the power/intercom button for up to 8 seconds, the LED
indicator should ash red twice with a fast hang up tone. At this stage,
your headset has successfully reset.
NOTE: After pressing and holding the power/intercom button for
approximately 3 seconds, the LED indicator will ash red once and
the voice prompt will say 'power off'. At this stage your headset has
switched off but not reset. Continue to press and hold the power/
intercom button for another 5 seconds (i.e., total time of about 8
seconds) for the headset to reset.
NOTE: Resetting the headset erases all Bluetooth
®
connections and any
intercom pairings with other headsets.