Signode BXT2-19 - Setting Welding Time; Setting Mode of Operation

20
10.13
SIGNODE BXT2-19
5.7 SETTING WELDING TIME
– Pressthe„Function“button(13/1)briey.
– Press the „Welding time“ button (13/2) until the
 ashingdigitaldisplay(13/3)showstherequired
welding time. Wait two seconds until the new setting is
saved.
1 = minimum welding time
7 = maximum welding time
+ / -
➟
Fig. 13
1
2
3
=
1.
2.
➟
1
2
Fig. 14
MAN.
AUTO
MAN.
SOFT
➟
blinkend / ashing /
clignote
AUTO
MAN.
SOFT
➟
AUTO
MAN.
SOFT
➟
AUTO
MAN.
SOFT
AUT
O
MAN.
+
AUT
O
3 4
5
6
5.8 SETTING MODE OF OPERATION
– Press“Function“button(14/1)briey.Thedigital
display will show “F“ (Function). The present mode of
operation is shown.
– Then press the “Mode of operation“ button (14/2)
 brieyuntilthedesiredmodeofoperationisshown.
Semi-automatic strapping (Standard):
Strapping is performed by pressing the tensioning button.
When the strap tension is reached, welding and cutting
is performed automatically. (If desired, by pressing the
welding button the welding can be triggered at any time,
from series no C/133700).
– Press“Function“button(14/1)briey.
– Press the “Mode of operation“ button (14/2). When the
“AUTO“ (14/3) and “MAN“ (14/4) LED indicators light
continuous green “Semi-automatic“ mode of operati-
on is selected.
Fully automatic strapping:
Strapping is performed by tapping tensioning button.
Tensioning, welding and cutting are performed fully-
automatically.
– Press“Function“button(14/1)briey.
– Press the “Mode of operation“ button (14/2). When the
 “AUTO“LEDindicator(14/5)ashesgreen“Fully
automatic“ mode of operation is selected.
STOP OF FULLY AUTOMATIC SEQUENCE:
By pressing tension- /welding button (recommended)
or raising rocker lever again.
Frequent operation of the rocker lever with
the strap under tension will lead to increased
wear on the pawl parts (Pos. 60,65/page 34).
Manual strapping (manual welding):
Strappingisperformedbyrstpressingthetensioning
button (1.). When the tension is reached, press the
welding button (2.).
– Press“Function“button(14/1)briey.
– Press the “Mode of operation“ button (14/2). When the
“MAN“ LED indicator (14/6) lights continous green
“Manual“ mode of operation is selected.