Signode BXT2-19 - Table of Contents

4
10.13
SIGNODE BXT2-19
www.signode.com
SIGNODE ENGINEERED PRODUCTS
Hand Tool Division
3610 W. Lake Avenue,
Glenview, Illonois 60025
DECLARATION OF CONFORMITY
We take sole responsibility for declaring that the tool
BXT2-19 to which this declaration refers is in full
conformity with the current requirements of the
guidelines laid down by the council on 17th May 2006
(2006/42/ECC), “Machine Guidelines“.
Furthermore, electrical installations are in conformity
with the guideline laid down by the council on 12.
December 2006 (2006/95/EEC) “Low Voltage Guide-
lines“ and 15. December 2004 (2004/108/EEC)
“EMV Guidelines“.
Harmonised standards applied:
EN ISO 12100-1, EN ISO 12100-2, EN 349,
EN ISO 14121-1, EN 61000-6-1, EN 61000-6-3
 EEC-Designcertication:No1203
 Placeofcertication:NSBIVAG,SIBECH
04.09.2009
General Manager General Manager Prod.
Packaging Technology: Packaging Technology:
U. Schweizer M. Binder
TABLE OF CONTENTS
Page
SHORT INSTRUCTIONS 2
1 Technical data 6
2 General information 8
2.1 Information on environmental protection 8
3 Safety instructions 10
4 Description 12
4.1 Construction 12
4.2 Operating panel 12
4.3 Function 12
5 Operating instructions 14
5.1 Charging the battery 14
5.2 Operating the tool 14
5.3 Checking the seal 18
5.4 Checking battery charge 18
5.5 Setting strap tension 18
5.6 Setting soft tension 18
5.7 Setting welding time 20
5.8 Setting mode of operation 20
5.9 Setting strap width 22
6 Special functions 24
6.1 Switch touch-pad lock on and off 24
6.2 Sleep mode 24
6.3 Tool reset 24
7 Preventive and corrective maintenance 26
7.1 Cleaning/replacing tension wheel 26
7.2 Cleaning/replacing tooth plate 26
7.3 Replacing knife 26
7.4 Trouble shooting 28
8 Wearing parts / Recommended spare parts 30
8.1 Parts list 30
Exploded drawing 34