SIKA TD 32500 Operating Manual
5.2.4.2.4 Programming the point of hysteresis 1 (2):
• The message „SET HYSTERESIS 1 (2)– NO“ appears.
• Switch with the ▲ key to „YES“ and confirm with the
key.
• The message appears „VALUE OK ?“ together with the last entered
hy
steresis point.
• Switch with the ▲ key to „CHANGE VALUE ?“ and confirm with the
key.
• A cursor appears. Set with the ▲ key the respective digit of the new
hysteresis point and confirm it with the
key.
• Quit the configuration menu, return to the menu start or continue to
c
onfigure the successive parameters.
5.2.5 Programming analogue output
You can only carry out this programming if TD 32500 is equipped with an
analogue output.
With this programming you select the source (flow rate, total flow
(resettable), or -if available- temperature), the type of the analogue output
(0-20 mA, 4-20 mA or 0-10 V) and the range of the analogue output.
Proceed as follows:
• Switch over to configuration menu.
• Press the
key until the message „SET ANALOG-OUT – NO“ appears.
• Switch with the ▲ key to „YES“ and confirm with the
key.
To Next Page
Loading...
Need help?
General
