SIKA TD 32500 User Manual

SIKA TD 32500 Operating Manual
5.2.6 Programming frequency divider
You can only carry out this configuration, if TD 32500 is equipped with a
frequency divider output.
With this programming you determine the factor by which the input pulse
rate generated by the flow sensor is divided in order to allow output at a
smaller pulse rate.
Note: If the built-in flow sensor provides for example a pulse rate of
855 pulses/liter (printed on type plate) and a factor "6" is
programmed, a pulse rate of 142,5 pulses/liter is quoted at the outlet.
P
roceed as follows:
• Switch over to configuration menu.
• Press the
↵
key until the message
„SET PULSE DIVIDE – NO“ appears.
• Switch with the ▲ key to „YES“ and confirm with the
↵
key.
• The message appears „VALUE OK ?“ together with the last entered
fa
ctor.
• Switch with the ▲ key to „CHANGE VALUE ?“ and confirm with the
↵
key.
• A cursor appears. Set with the ▲ key the respective digit of the new
factor and confirm it with the
↵
key.
5.2.7 Quit configuration menu
• The message „QUIT CONFIG – NO“ appears.
• Switch with the ▲ key to „YES“ and confirm with the
↵
key.
• The configuration menu is quit. TD 32500 switches back to
m
easurement operation.
• If you confirm with "NO", the system returns to the beginning of the
configuration menu.
Note: By simultaneous pressing the keys ▲ and
↵
at any position in
the configuration menu, the instrument switches to the menu item
"Quit configuration menu".

SIKA TD 32500 Specifications

General

Brand	SIKA
Model	TD 32500
Category	Measuring Instruments
Language	English