Silca Speed - Installation Steps and Mains Connection; Installing Parts and Mains Connection Safety

3.5 Separate parts
The separately packed parts must be installed on the SPEED key-cutting machine by the purchaser, as follows:
Carriage lever handle
Screw the handle (B) onto the carriage lever (Fig.10).
Fig.10
Power cable
Connect the key-cutting machine power cable to the electricity mains (Fig.11).
Fig.11
3.6 Connection to the mains
For the safety of the operator and the machine it is important to ensure that the machine is connected to the proper
mains voltage by means of an earthed differential switch.
Operating manual SPEED
Copyright Silca 2013
11