Need help?Do you have a question about the Silca Speed and is the answer not in the manual?
Explains the manual's importance and the machine's identification plate.
Information on obtaining service and warranty details.
Explains the meaning of symbols used in the manual and on the machine.
Guidelines for normal operation and essential safety rules.
Details on machine safety, cutter motor protection, and general precautions.
Introduces the main parts of the key-cutting machine.
Specific components of the cutting unit, including tool, tracer, and clamps.
Detailed diagram labeling all main parts of the machine.
Details on power supply, motor, dimensions, and noise level.
List of electrical components and circuit diagram.
Listing of all accessories, tools, and spare parts supplied with the machine.
Procedures for safely transporting, unpacking, and handling the machine.
Checks for damage, environmental conditions, and positioning.
Description of the work station and operator controls.
Attaching handle, connecting power cable, and mains safety.
Introduction to axis and depth calibration procedures.
Detailed steps for calibrating the cutting depth.
How to adjust the tracer point for precise cut depth.
Essential safety rules to follow during cutting operations.
Instructions on positioning keys in clamps for cutting.
Procedures for rotating clamps and securely positioning keys.
Steps for cutting keys and using accessories like pins.
How to use bars for cruciform keys and as a tip rest.
Guidelines for cleaning, general upkeep, and safety during maintenance.
Step-by-step guide for replacing the brush.
Detailed procedure for replacing the cutting tool, including thread direction.
Instructions for replacing the tracer point.
How to adjust depth to protect clamps.
Procedure for replacing machine fuses, noting correct types.
Steps to access the lower section of the machine.
Step-by-step guide to replacing the main power switch.
Comprehensive guide for replacing the motor.
Connecting electrical components and securing covers after motor replacement.
Procedure for replacing or adjusting the drive belt tension.
Steps to replace the switch associated with the motor.
Instructions for replacing the machine's condenser.
Guidelines for disposing of waste and information on electronic equipment.
Information on manufacturer assistance and how to request service.
To Next Page
General