Operation Manual S15
Page
12
4.7 CHANNEL 16 (16)
Pressing (16) key will automatically select channel 16 on high power. Any
active function (Dual watch scanning, DSC setting, log view, NAVTEX
GPS setting etc) will be cancelled.
4.8 CHANNEL SELECT (▲ / ▼)
Press
▲
key to go up through the channels. Press
▼
key to go down
through the channels.
Channel Selection Shortcut:
Select the desired channel directly from the main screen by pressing the
channel number on the fist microphone/controller, and then press “ENT”
to confirm.
4.9 MEMORY CHANNEL SETTING (M+)
Pressing the (M+) key will add the currently selected channel into the
scan memory. When operating in VHF receiver mode, if the key is
pressed the screen will show “M” on the bottom right of the LCD
indicating that the channel has been entered into the scan memory. By
pressing the (M+) key again, the “M” will be deleted indicating that the
channel is not a memory scan channel
To Next Page
Loading...
Need help?
General