Operation Manual S15
Page
37
The “waypoint number” represents the number of waypoints. You can
find the “waypoint number” under the directory of “Waypoint Overview”.
For example, if the waypoint number shows “05”, it means that there are
5 waypoints stored. Please note that the maximum storage for waypoints
is 50. If the storage exceeds the maximum storage, the display will
indicate “Invalid Data” to express that the input is invalid. The screen
setting will go back to SET WAYPOINT NUMBER automatically after 1
second approximately for data to be input again.
11.2 Set Waypoint
Press ▲ or ▼ key to move the symbol ► on the GPS NAVIGATION
setting screen to the front of SET WAYPOINT, then press
(ENT)
to
confirm. The SET WAYPOINT screen will appear as below.
With this function, you can enter the positions that you want to approach
and the position of your destination. You can then display the distance,
bearing and speed from your current position to the destination.
Please note that you cannot input the waypoints more than 50 positions.
Otherwise, the input will be invalid.
Input Longitude and Latitude with the numeric keys on the microphone.
When you move the cursor to “N” and “E”, press “0” on the microphone to
convert Longitude and Latitude to “S” and “W”.
You can name each waypoint position. If you do not name the waypoint
positions, the default setting will be counting from “WPT01”. The
maximum number of name character is 10.
To Next Page
Loading...
Need help?
General