Operation Manual S15
Page
28
Use the numeric soft keys to enter the GROUP ID numbers (8 numbers,
the first number must be “0”). If a mistake is made, use the ◄ or ► key to
move the cursor on the screen back and reset the number. Then press
(ENT) key, the radio will ask for verification. If sure, press (ENT) key once
again to confirm the entered numbers. If no, press (CLR) key to go back
to last screen.
9.3 SET DATE AND TIME
Press ▲ or ▼ key to move the ► symbol on the DSC SETTING screen
in front of DATE/TIME, then press
(ENT)
key, the SET DATE/TIME
screen will appear.
Use the numeric keys to enter the numbers, then press (ENT) key to
accept the date and time.
Note that the time should be entered in 24 hour clock format.
9.4 SET MANUAL POSITION/UTC
To Next Page
Loading...
Need help?
General