Operation Manual S15
Page
27
To view your vessel MMSI, press
(MENU)
key on the mike keypad to
select the MENU SELECTION screen. Press ▲ or ▼ key on the mike
keypad to select the DSC SETTING screen as below:
Press
▲
or
▼
key again to move the symbol ► on the screen to front of
MMSI, and press (ENT) key to confirm. The MMSI VIEW screen is as
below:
Press (CLR) key on the mike keypad to go back to DSC SETTING
screen, or press (CLR) key on the front panel to go back to main screen.
To change the MMSI number after it has been programmed the unit must
be returned to an authorised dealer to erase the existing number.
9.2 SET GROUP ID
To enter a Group ID (if for example the vessel is part of a flotilla or fishing
fleet etc), press
▲
or
▼
key to move the ► symbol on the DSC
SETTING screen in front of GROUP ID, then press (ENT) key to confirm,
GROUP ID SET screen will be displayed as follows:
To Next Page
Loading...
Need help?
General