Operation Manual S15
Page
19
Press the (ENT) key again to make the call, or press (CLR) for cancel.
When the call is sent, the radio will be set to the working channel. Allow a
few seconds for the stations receiving the call to switch to the working
channel. Then make a normal voice call on the selected working channel.
6.4 GROUP CALL
If a group ID has been set up for the called Radio. A call can be made to
other members of the group.
Press the (CALL) key on the keypad to select the group call screen as
follows:
Select a working channel from the channel list by pressing the
▲
or
▼
keys on the keypad.
Press
(ENT)
key to send the call, allow a few seconds for the other
members of the group to reach the radios (all VHF radios in the group
should automatically switch to selected working channel upon
acknowledgement), then make a normal voice call.
To Next Page
Loading...
Need help?
General