■ 8 │ GB
│
CY
SKV 1200 A1
NOTE
► If you wish, you can open the filling opening
8 on the lid 9 so that you can also fill in
ingredients during operation.
7) Turn the rotary switch 3 to the required level
(see the section “Speed settings”).
After you have finished using your
appliance
1) Turn the appliance off using the rotary switch 3
(Position “0”).
2) Press down the release lever 2 and move the
swivel arm 1 to the highest position.
3) Remove the attachment 0 q w from the
socket 7 by pressing the attachment 0 q w
lightly against the socket 7 and turning it
clockwise at the same time (in the direction
of the arrow
). Then you can remove the
attachment 0 q w.
4) If fitted: remove the lid 9.
5) Remove the mixing bowl 6 by turning it anti-
clockwise and then pulling it upwards.
6) Clean the appliance (see section “Cleaning
and care”).
Working with the blender
WARNING! RISK OF INJURY!
► Always allow hot fluids to cool down to a
lukewarm temperature (approx. 30–40°C)
before adding them into the blender t.
WARNING! RISK OF INJURY FROM
SHARP BLADES/ROTATING DRIVE
UNIT!
► Never put your hand into the attached
blender t!
► Do not remove the blender t unless the
blades z are stationary.
► Operate the blender t only when the blender
lid r with the measuring cup e are attached.
► In cases of malfunction, switch the appliance
off and remove the plug from the wall socket
to prevent the appliance from being switched
back on unintentionally.
ATTENTION! PROPERTY DAMAGE!
► Never use the mixing bowl 6 and blender t
at the same time! This will overload the motor!
► When working with the blender t we recom-
mend allowing the appliance to cool down
after 3 minutes of operation.
Proceed as follows to prepare the blender for
operation t. Use figure C on the rear fold-out
page as a guide.
1) Press down the release lever 2 and press the
swivel arm 1 downwards into the working
position.
2) Turn the drive protection cover u clockwise so
that the arrow on the drive protection cover u
is pointing to the
symbol on the appliance.
Remove the drive protection cover u and
place it to one side.
To Next Page
Loading...
