- 44 -
Edit / Select TP
You can make a manual selection of the transponder. Various numbers of
transponders are preset according to the selected satellites.
Press the arrow keys left (10) or right (11) to select one of the preset
transponders.
or
Press the OK key (14) to reach the Transponders List editor.
Please read the item Transponder-List editor on the pages below.
Start scanning
This item is to start scanning with the set parameters.
Press the “OK” key (14).
or
Press the red key (17) even if you have not marked the point "Start
scanning".
A "Scanning" window opens up. This shows you the progress of the scan and
the channels found.
Press the red key (17) to abort the scan.
To Next Page
Loading...
