- 5 -
Safety instructions
Please read the safety instructions carefully before operating the receiver.
Please follow all warnings and instructions on the equipment and in the
operating manual.
Basic safety instructions
Electrical connection
• Disconnect the receiver from the power source in case of operational
disruptions. Please note: The receiver will remain live, even if it is turned off
from the mains switch on the rear side.
• Do not expose the receiver to rain or any kind of humidity to avoid risk of
fire and electric shock.
• Never open the casing. Otherwise, there is a risk of electric shock. There
are no serviceable parts inside.
• Connect the receiver only to a professionally installed mains socket of 100–
240 V ~, 50–60 Hz.
• The total power consumption by the antenna connection of the receiver
“LNB IN” must not exceed 300 mA.
• Pull out the mains plug from the socket if the equipment is not in use for a
relatively long period of time. Only pull at the mains plug, not at the cable.
• Do not touch the power cable with moist or wet hands.
• In the event of storms, pull out the mains plug of the receiver from the
socket.
• The Standby key (device front) of this device will not separate the device
completely from the power source. To isolate the device completely from
the power circuit, operate the On/Off switch on the back of the unit.
• Thread off the connecting cable (satellite supply line) from the receiver, in
the event of a storm.
• If foreign bodies or fluids enter the receiver, immediately pull out the mains
plug from the socket. Ask a qualified person to check the equipment before
operating it again. Otherwise, there is a risk of electric shock.
• Do not place any objects or other things on the power cord.
To Next Page
Loading...
