Connecting the receiver
19
Connection with the YUV cable
If you own a TV set with YUV connections, you can
connect it via the SCART socket “TV“ to the receiver. For
this purpose, you need a YUV cable with YUV connectors
at one and a SCART connector with YUV element at the
other extreme.
Connect the YUV cable (not included in the scope of
supply) to the YUV connectors of the TV set.
Connect the SCART connector of the YUV cable to the
SCART socket “TV“ on the receiver.
Follow the indications in the operating manual of
the TV set.
Connect the SCART cable to the SCART socket
“VCR” on the receiver and connect it to the video set if
you want to connect a video set additionally.
As the YUV cable does not send an audio signal to the
TV set, you must connect your receiver with a stereo
system to hear the tone. For this purpose, use a Cinch
cable and insert the Cinch connector in the “AUDIO-R“
and “AUDIO-
Alternatively, you can also connect an audio digital
receiver to your receiver to get a 5-channel audio
transmission. Use the digital audio output "COAXIAL"
for this purpose. The connection diagram can be found
on the following pages.
The YUV cable is not included in the scope of
supply.
Follow the indications in the operating manual of
the video recorder.
To Next Page
Loading...
Need help?
General
