Silvercrest SL35T User Manual

STBY
SL 35 T
ON
Digitaler terrestrischer Receiver
CH-
C
-
CH+
#
Faulty-Description:
GUARANTEE
Sender please use block-writing in boxes with CAPITAL LETTERS
Surname
Firstname
Street
Postcode and city
Telefon no. with areacode
Signature of buyer
PLEASE CUT THIS CARD AND ENCLOSE IT TO THE RETURNING GOOD
•
•
f
r
o
m
p
u
r
c
h
a
s
e
-
d
a
t
e
•
•
•
•
3
6
m
o
n
t
h
s
•
•
Guarantee
Model / Type: SL 35 T
Overview of equipment
Front side of the receiver
Rear side of the receiver
Remote control
Overview of equipment
Front side of the receiver
1 – Infrared sensor for the signal of the remote control
2 LED STBY LED is illuminated if the receiver is in standby mode
3 LED ON LED is illuminated if the receiver is switched on
4 STANDBY Switches on and switches to the standby mode
The default settings will be restored if you keep this key
pressed for more than 10 seconds.
Caution! By doing this, your personal settings will be
deleted.
5 CH – Switches to the next lower channel location
Cursor moves down
6 CH + Switches to the next higher channel location
Cursor moves up
Rear side of the receiver
1 ANT IN Coaxial connection for the antenna cable
2 ANT OUT Coaxial connection for a second receiver
3 VCR SCART connection for the video set
4 TV SCART connection for the TV set
5 100 – 240 V~ Mains connection
50/60 Hz, 20 W
6 ON/OFF Mains switch
7 RS 232 Serial port
8 COAXIAL Digital coaxial audio output
9 AUDIO L Left stereo audio connection
10 AUDIO R Right stereo audio connection
Zintek Systems Ltd
Zintek House
Eurohaul Centre
Greenhills Road
Tallaght
Dublin 24
Service-Hotline:
00353 (0) 1400 8353
E-Mail:
info@zintek.tv
100% Black+Silver
for light surfaces

Silvercrest SL35T Specifications

General

Brand	Silvercrest
Model	SL35T
Category	Receiver
Language	English