Silvercrest SRH 5 C3 - Page 23

■ 20 │ GB
│
IE
│
NI
SRH 5 C3
Scan setting
The Scan setting function allows you to set whether all receivable FM radio
stations should be found during a scan or only radio stations with a strong
reception signal.
♦ In FM radio mode, press the INFO / MENU button
4 for approx.
2 seconds. The following appears on the display Scan setting.
♦ Press the VOLUME |
ENTER/SCAN dial6 to confirm the selection.
♦ Press the TUNE+
8 or TUNE−7 button or turn the VOLUME |
ENTER / SCAN dial6 to select Strong stations only or All stations.
♦ Press the VOLUME |
ENTER/SCAN dial6 to confirm the selection.
Saving your favourite stations
♦ To store the current radio station manually, press the PRESET button 5 for
approx. 2 seconds. The display1 shows the preset with the last selected
radio station (if radio stations have already been stored). If no radio stations
have yet been stored, the display1 shows Store preset 1: (Empty).
♦ Briefly press the TUNE+
8 or TUNE−7 button (several times if necessary)
or turn the VOLUME |
ENTER / SCAN dial6 to select the desired
preset.
♦ Press the VOLUME |
ENTER/SCAN dial6 to store the station in
the selected preset. The display
1 shows Preset (1-40) stored.
NOTE
► Stored radio stations are overwritten if you store other stations in station
presets that are already occupied.