GB
│
IE
│
NI
│
CY │ 13 ■
SSRA C2
♦ Remove obstacles such as power cords, toys
and other objects before use.
♦ Fold the carpet edges under the carpet. Do
not leave curtains and tablecloths hanging
on the floor.
♦ Try to position furniture so that it does not
obstruct the appliance.
♦ Do not stand in the area where the appli-
ance is working. Otherwise, the appliance
will not be able to clean these areas.
♦ Test the appliance in areas with stairs. This
allows you to determine whether it can
recognise the edge of the fall area.
Vacuuming
♦ In standby mode, briefly press the On/Off
button 1 on the appliance or the Start/
Pause button on the remote control 6 or
select cleaning mode Auto in the main menu
of the app (see section Control via the LIDL
Home app). A beep sounds and the On/Off
button 1 and the Home button w
on the appliance light up blue.
♦ The appliance starts operating in cleaning
mode Auto.
Pausing the cleaning process
♦ During operation, briefly press the Start/
Pause button on the remote control 6 or
select Standby in the main menu of the app
(see section Control via the LIDL Home app)
to interrupt the cleaning process. A beep
sounds, the On/Off button 1 flashes
blue and the Home button w goes out.
The appliance is in standby mode.
♦ While the appliance is in standby mode,
you can use the direction buttons on the
remote control 6 to control its movements
to the left/right/forward/backward.
♦ In standby mode, briefly press the On/Off
button
1 on the appliance or the Start/
Pause button on the remote control 6 or
select cleaning mode Auto in the main menu
of the app (see section Control via the LIDL
Home app) so that the appliance continues
the cleaning process. You can also select
a different cleaning mode using the remote
control 6 or the app (see chapter Selecting
a cleaning mode/Control via the LIDL
Home app).
Note
► After three minutes in standby mode, the
appliance is automatically switched to sleep
mode. The On/Off button
1 and the
Home button w (and the Wi-Fi LED
e when controlled via the app) on the
appliance go out.
♦ If the appliance is in sleep mode, briefly
press the On/Off button 1 on the ap-
pliance or the Start/Pause button on the
remote control 6 or select Standby in the
main menu of the app (see section Control
via the LIDL Home app) to switch the appli-
ance back to standby mode.
You can also start the appliance again
directly via the app by selecting a cleaning
mode.
Note
► If the appliance resumes the cleaning pro-
cess after a pause, it will re-plan the area
and possibly clean the area that has already
been cleaned again.
► If you have two robot vacuum cleaners, both
appliances may accept commands from the
one remote control at the same time.
IB_452854_SSRCA2_LB6_IE-NI-CY.indb 13 29.04.2024 07:38:13
To Next Page
Loading...
