Silvercrest SSRM 20 A1 - Storing stations manually; Calling up preset stations

SSRM 20 A1
■ 16
│
GB
│
IE
│
NI
Storing stations manually
You can store up to 20 stations or frequencies in the radio
memory.
♦ While the radio is on, briefly press the MODE /
button
to switch to the search mode. The
symbol flashes on
the display
.
♦ Select a station to store.
♦ Press the MEM/AL button and hold it until the display
reads PRESET.
♦ Use the "‒"
or "+" button to select a station preset
between
and .
♦ Briefly press the MEM/AL button . Once the display
returns to showing the frequency, the station has been
stored in the selected preset. This process overwrites the
station that was stored in the same space previously.
♦ Press the MODE /
button to exit this mode.
The
symbol will light up permanently again.
Calling up preset stations
♦ While in radio mode, briefly press the MEM/AL button .
The most recently used station preset (e.g.
) is shown
on the display
.
♦ Use the "‒"
or "+" button to select a station preset
between and . After approx. 3 seconds, the
station stored in the preset will start playing.
IB_312011_SSRM20A1_LB6.indb 16 19.12.18 14:33