19-6432-M-01 Rev 4 24
3.3 Cleaning the Emitter Points
Turn off the unit. Normally, the emitter points can be cleaned by
using a jet of compressed air to blow off any dirt that may have
accumulated on them. A swab moistened with the IPA solution may
be used if required. If using a swab, gently wipe the tips of the
emitter points until all the dirt is removed.
Wire emitter points should not be bent or moved during cleaning.
After cleaning make sure that the emitter wires point to the center of
the fan and are on the same horizontal plane.
The Blower uses internally-shielded emitter points that will not
normally require replacement during the service life of this product.
If you believe that the emitter points need to be replaced, contact
Simco-Ion Technical Support (techsupport@ion.com) for
information.
Caution:
Before performing any maintenance on emitter points, remove
the power plug from the ionizer. Allow a minute for the high
voltage power supply to discharge.
Achtung:
Ziehen Sie vor der Durchführung von Wartungsarbeiten an
Emitter-Punkten den Netzstecker aus dem Ionisator. Lassen
Sie die Hochspannungs-Stromversorgung eine Minute
entladen.
To Next Page
Loading...
