SimCom SIM7800 Series - AT+CFTPSPUTFILE Put a File from Module to FTP(S) Server

Smart Machine Smart Decision
SIM7500_SIM7600_SIM7800 Series_FTPS_AT Command Manual 12 / 29
Execute Command
AT+CFTPSGETFILE=
“<filepath>” [,<dir>]
Response
a) if download file successfully :
OK
+CFTPSGETFILE: 0
b) if failed:
OK
+CFTPSGETFILE: <errcode>
c) if parameter format or any other errors:
ERROR
Defined Values
<filepath>
The remote file path. When the file path doesn’t contain ”/”, this
command transfers file from the current remote FTPS directory.
If the file path contains non-
ASCII characters, the file path
parameter should contain a prefix of {non-
ascii}.String type,
maximum length is 256
< dir >
The directory to save the downloaded file. Numeric type, range
is 1-4， default is 1(/cache)
1 – F:/ (/cache)
2 – D:/(sd card)
3 – E:/ (/data/media/)
4 – /mssl_cert/(this is for CA file downloading)
<errcode>
The result code of download file from FTP(s) server.
0 is
success, others are failure, please refer to chapter 4.
2.13 AT+CFTPSPUTFILE Put a file from module to FTP(S) server
You can use this command to upload a file to FTP(S) server from module. By setting parameter <dir> you can
select the directory that contains the file to be uploaded. Make sure that you have login to the FTP(S) server
successfully before AT+CFTPSPUTFILE.
AT+CFTPSGETFILE Download a file from FTP(S) to module
Test Command
AT+CFTPSPUTFILE=?
Response
+CFTPSPUTFILE:
[{non-ascii}]"FILEPATH"[,(1-3),(0-2147483647)]
OK
Execute Command
Response