13
5. engine operation (cont.)
5.2 Adding Fuel
WARNING
• Make sure there is enough fuel in the fuel tank before
operating the pressure washer.
• Use only clean, fresh, unleaded fuel. Use a minimum of
87 octane/87 AKI (91 RON).
• Do not use old gas, and do not mix oil with gasoline.
• Fuel and its vapours are extremely ammable and
explosive. Fire or explosion can cause severe burns or death.
IMPORTANT
• Keep fuel away from sparks, open ames, pilot lights, heat,
and other ignition sources.
• Check fuel hoses, tank, caps, and ttings for cracks or leaks.
Replace if necessary.
• If fuel spills, wait until it evaporates before starting engine.
• Fill the fuel tank outdoors or in well-ventilated area.
S
Fuel Tank Capacity: 1.2 L
1. Stop the engine (gStopping Engine) and let it cool at
least 2 minutes before removing the fuel tank cap.
2. Clean the fuel cap area of dirt and debris. Remove the
fuel tank cap and make sure the fuel lter is in place.
3. Fill the fuel tank with fuel. Never overll the fuel tank.
Fill tank to no more than 1/2 inch (13 mm) below the
bottom of the ller neck to provide space for expansion
caused by the engine heat. To allow for expansion of the
fuel, do not ll above the bottom of the fuel tank neck.
4. Reinstall the fuel tank cap.
Engine Operation
UG01_2700PSI_E.indd 13 2016-12-01 5:32 PM
To Next Page
Loading...
