12
5. engine operation
5.1 Adding/Checking Oil
IMPORTANT
Oil has been drained for shipping. Failure to ll engine with
oil before starting engine will result in permanent damage
and will void engine warranty. Add oil according to the
instructions.
IMPORTANT
Before each use:
• Check the oil and fuel level and ll if necessary.
• Make sure that the spark plug, muer, fuel cap, and air
lter are in place and secured.
• Do not crank engine with spark plug removed.
WARNING
• Always check the oil level before starting the engine,
making sure the pressure washer is on a level surface.
• Always use oil type SAE 10W-30, which can be found at
your local Canadian Tire store (Product no. 28-9301-6).
TIP: When adding oil use provided oil funnel.
A
10W-30
Engine Oil Reservoir Capacity: 0.5 L
1. Remove oil tank dipstick and wipe it with a clean cloth.
2. Replace and retighten the dipstick .
3. Remove the dipstick again and check the oil level. It
should be at the top of the full indicator on the dipstick.
4. If low, add oil slowly into the oil tank. Do not overll. After
adding oil, wait one minute and then recheck the oil level.
5. Replace and retighten the dipstick.
Engine Operation
UG01_2700PSI_E.indd 12 2016-12-01 5:32 PM
To Next Page