Simoniz 039-8055-2 - Leaning with D

18
6. cleaning with detergent inStructionS (cont.)
6.2 Working with the Foam Blaster (cont.)
d
1. Attach the foam blaster onto the spray gun.
2. Apply the detergent to a dry work surface from bottom
to top.
3. Allow detergent to remain on the surface for a short
time before rinsing. Do not allow detergent to dry on
the surface.
4. When you are nish working with detergent, ll with
clean water in bottle and spray water for one minute in
ON position to rinse the Foam Blaster and remove any
soap residues that may clog it.
CAUTION
Damage may occur to painted surfaces if chemicals are
allowed to dry on them. Wash and rinse a small section
at a time.
f
1. Set detergent ON/OFF knob to ON position to work with
detergent.
2. Set detergent ON/OFF knob to OFF position for cleaning
surface without detergent.
CAUTION
Failure to clean the foam blaster properly will cause
the detergent injection system to become clogged and
inoperable.
g
1. Pencil spray (slide collar backwards) to reach 2nd oor.
2. Fan spray (slide collar forwards) to apply detergent more
eciently. Fan spray can be adjusted 90 degrees to spray
either horizontally or vertically.
Cleaning with Detergent Instructions
Detergent
ON
Detergent
OFF
Pencil spray Fan spray
UG01_2700PSI_E.indd 18 2016-12-01 5:32 PM