15
Step 1
End of detergent application. (If you are not
using detergent, go directly to Step 2.)
When you have finished using the detergent
injection system, remove detergent suction tube
from bottle and insert into 1 gallon (5 L) of fresh
water. Siphon water at low-pressure for one
minute so that all detergent is flushed through
system. Remove detergent bottle and rinse it
until it is thoroughly cleaned.
Step 2
Turn the switch to “OFF” (0) position and unplug
cord from outlet.
Step 3
Unplug the power cord from the outlet.
Step 4
Press trigger to release water pressure.
Step 5
Disconnect the garden hose from the water inlet
on the unit.
Step 6
Disconnect the high-pressure hose from the high-
pressure outlet and engage the gun safety lock.
Step 7
Wind high-pressure hose and electrical cord
around the handle as shown.
SHUTTING DOWN AND CLEANING UP
If taking a break of five minutes or more:
Step 1
Engage gun safety lock.
Step 2
Turn pressure washer to “OFF” (O) position.
Step 3
Unplug the power cord from the outlet.
TAKING A BREAK
Warning
Turn off water supply and squeeze trig-
ger to depressurize the unit. Failure to
do so could result in personal injury due
to discharge of high-pressure water.
To Next Page
Loading...
