7
5. ASSEMBLY INSTRUCTIONS
5.1 Surface Preparation
Before beginning any cleaning task, it is important to inspect the
area for objects that could create a hazard. Remove any objects
from the work area that could be tripped over, such as toys or
outdoor furniture. Ensure that all doors and windows are closed
tightly.
5.2 Water Supply (Cold Water Only)
Only draw water through the unit. The device must be used with
cold water supply only. The water hose must be at least 13mm
(1/2”) in diameter. The water ow rate must not fall below 9.1
litres per minute (2 gallons per minute). The ow rate can be
determined by running water for one minute into an empty
container. The water supply temperature must not exceed 40°C
(104°F).
5.3 Safety Advice
CAUTION
• Never use the pressure washer to draw in water
contaminated with solvents (e.g. paint thinners,
gasoline, oil, etc.).
• Dirt in the water inlet will damage the unit. To avoid this
risk, we recommend checking the water lter (located
inside the water inlet. To clean it out, refer to the Cleaning
and Maintenance section).
• Always prevent debris from being drawn into the unit by
using a clean water source and an additional accessory
water lter, if required.
• To prolong the life of the unit, let it rest for 5 minutes
after every 30 minutes of use.
• Check to make sure you have all the parts.
5.4 Assembly Steps
A
Assemble the gun holster and cord bracket.
S
Fully unwind and detach hose from the reel.
D
Attach the high pressure hose to the gun and pump outlet
(hand tighten only).
Assembly Instructions
To Next Page
Loading...
