10
Operating Instructions
6. Operating Instructions
6.1 Working with the Foam Blaster
Working with a detergent ensures quick soaking of the dirt,
and allows the high-pressure water to penetrate and remove
the dirt more effectively. Always spray detergent on a dry
surface, do not pre-soak the area. Wetting the surface first
dilutes the detergent and reduces its cleaning ability.
CAUTION
Damage may occur to painted surfaces if chemical are
allowed to dry on them. Wash and rinse a small section
at a time.
1
3
2
1. Detach spray head by turning detergent bottle 1/4
counter-clockwise.
2. Fill the bottle with the detergent.
3. Attach the spray head on the bottle by turning 1/4
clockwise.
1. Attach the foam blaster onto the spray gun.
2. Apply the detergent to dry work surface from bottom
to top.
3. Allow the detergent to remain on the surface for a
short time before rinsing. DO NOT allow the detergent
to dry on the surface.
4. After finish working with detergent, fill the clean
water in the bottle and spray water for one minute in
ON position.
To Next Page
Loading...
