7
MODEL: VE 26 / 039-8119-2
5. Assembly Instructions
5.1 Surface Preparation
Before beginning any cleaning task, it is important to inspect
the area for objects that could create a hazard. Remove
any objects from the work area that could be tripped over,
such as toys or outdoor furniture. Ensure that all doors and
windows are closed tightly.
5.2 Water Supply (Cold Water Only)
Only draw water through the unit. The device must be used
with cold water supply only. The water hose must be at least
1/2” (13 mm) in diameter. The water flow rate must not fall
below 2 GPM (7.6 LPM). The flow rate can be determined by
running water for one minute into an empty container. The
water supply temperature must not exceed 40°C (104°F).
5.3 Safety Advice
CAUTION
•
Never use the pressure washer to draw in water
contaminated with solvents (e.g., paint thinners,
gasoline, oil, etc.).
•
Dirt in the water inlet will damage the unit. To avoid
this risk, we recommend checking the water filter
located inside the water inlet. To clean it out, refer to
the Cleaning and Maintenance section.
•
Always prevent debris from being drawn into the
unit by using a clean water source and an additional
accessory water filter, if required.
•
To prolong the life of the unit, let it rest for 5 minutes
after every 30 minutes of use.
•
Check to make sure you have all the parts.
5.4 Assembly
Unfold the handle and
fasten the handle lock
Assemble gun holder,
wand holder, and
cable hodler.
Attach high
pressure hose to
gun and pump
outlet respectively
(hand tighten only).
1
2
3
Assembly Instructions
To Next Page
Loading...
