11. Using the installation tool, push the slider on the inside of the inlay back
to the home position.
12. Reapply the inner cover until it is flush with the door.
13. Reapply the inlay.
9 The inlay snaps back into place noticeably.
14. Carefully insert the installation tool from below into the inlay of the
outer cover.
15. Slide the installation tool into the inlay to unlock the inlay.
16. Carefully slide the inlay in the direction of the handle.
17. Slide the outer cover in the direction of the handle.
18. Carefully unlock the electronics.
19. Fold the electronics horizontally to the side.
20.Remove all batteries from the holder.
SmartHandle (Manual)
13. Battery replacement
118 / 136
To Next Page
Loading...