ATTENTION
Mechanical damage due to battery replacement
Pressure on the circuit board can damage the electronics.
Under no circumstances should you exert pressure on the circuit board!
21. Push the new batteries with the positive poles next to each other
quickly into the holder.
22. Fold in the electronics again.
23. Snap the electronics back into place.
24.Using the installation tool, push the slider on the inside of the inlay back
to the home position.
25. Reapply the outer cover until it is flush with the door.
26.Reapply the inlay.
9 The inlay snaps back into place noticeably.
9 The batteries have been replaced.
SmartHandle (Manual)
13. Battery replacement
119 / 136
To Next Page
Loading...