WIRING
CAUTION
1. Do not apply power until all connections are made and inspected.
2. Do not coil excess wiring inside receiver or transmitter.
I
8. Wire in accordance with Figure 5.
See below for a description of receiver and transmitter terminals and for detailed information on the 2098-9816 Re-
mote Indicator Plate.
r
-----A-
, r -------, r-------
~ANSMITTER
LAST
TRANSMITTER
RESElTAELE +
1
I
INITIATING
CIRCUIT
LISTED SIMPLEX
FIRE ALARM
CONTROL PANEL
4001. KXl2.
4100.0R2120
123456789
NOTES: I.
2.
3.
4.
RECEIVER
II
LAST
RECEIVER
I I
REF.
ONLY
-
REMOTE INDICATOR PLATE
(IF USED)
Transmitter 24VDC power can be independent of Receiver 24VDC.
See the 341-687 Field Wiring Diagrams supplied with each fire alarm control panel for correct resistor value
and additional interconnection information.
Style B (formerly Class B) wiring is shown in Figure 5. For Style D (formerly Class A) wiring, do not use
EOL resistor. Bring resistor connections back to initiating circuit.
Receiver Terminals 1 (NC), 2 (C), and 3 (NO) are for the Auxiliary Alarm Contacts rated at 1 amp, GOVDC.
Interconnection Data
FIGURE 5
6
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
