MOUNTING
1. For each receiver (A) and transmitter.(B) (see Figure 2), install a 4” (1 Ocm) square or octagonal electrical box
(not supplied) to a
rigid
surface that is not subjected to movement or vibration.
2098-9207 Long-Range Beam Detector
FIGURE 2
2. Remove the access door (C) on each receiver and transmitter by removing one screw (D). The Receiver and
the Transmitter may be identified by the label on the bottom of each cover. See Figures 2 and 3.
Removing Access Door and Cover
FIGURE 3
3. Remove the cover (E) on each receiver and tiansmitter by removing four screws (F). See Figure 3.
4
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
