SETTING UP
9.
After making sure that all connections are made and secure, apply power to both the receiver and transmitter.
10. Press the Aim Mode Button ((Z), see figure 8). This allows the transmitter to begin transmitting its signal while the
cover is off. Check the transmitter’s green LED indicator to make sure that it is flashing.
l
If green LED is OFF,
recheck for presence of power and proper polarity on transmitter terminals 1 (-) and 2 (+).
l
If
green LED is ON steady,
transmitter is faulty and must be replaced.
11.
Check the receiver’s three LED indicators to make sure that either all three indicators are ON or the red and yellow
indicators are ON and the green indicator is flashing.
l
If all LED indicators are OFF,
recheck for presence of power and proper polarity on receiver terminals 8 (-) and 9
(+I*
12. Obtain a Flasher Unit (Part No. 553-557). The Flasher Unit provides an excellent aiming light for use with the
2098-9207.
l
An aiming light may not be necessary if the distance between receiver and transmitter is 75’ (23m) or less.
13.
Lay the Flasher Unit (M) on top of the receiver with the lens side pointed towards the transmitter. See Figure 8.
14. Temporarily connect the flasher units power leads to the receiver’s terminals 8 (-) and 9 (+) - black lead to 8 and
red lead to 9.
.-
PRELIMINARY ALIGNMENT
Each transmitter’s optical module is equipped with two viewing ports (one on each side) for initial alignment. Use either
viewing port for Step 15.
NOTE: For steps 15 through 21, see Figure 8.
15. To initially align an optical module (N), look into either mirror (Q) from a side angle at least 2 feet from the module.
The optical module is pointed at objects seen in the mirror with the orange colored front bore sight even with the rear
bore sights (R).
16.
Rotate the optical module left or right through the detents (not shown) until you see the image of the aiming light (or
image of receiver if aiming light is not used) in the mirror.
l
If you initially aimed the module too high or too low, use the vertical fine-tuning adjustment screw (S) to slightly
adjust the module up or down until the proper image appears.
17. Use the vertical fine-tuning adjusment screw (S) and the horizontal fine-tuning adjustment screw (T) to fine-tune the
image at the center of the mirror (in line with the front and rear bore sights [P] & [RI).
18.
19.
Make sure that the transmitter’s green LED (U) is flashing.
Remove the Flasher Unit (M) from the receiver and lay it on top of the transmitter with the lens side pointed towards
the receiver.
20.
Temporarily connect the flasher unit’s power leads to the transmitter’s terminals 1 (-) and 2 (+) - black lead to 1
and red lead to 2.
21.
Repeat Steps 16 and 17 to align the receiver.
l
If the receiver’s green LED is flashing, remove the flasher unit from the top of the transmitter. If the green LED is
not flashing, repeat Steps 15 through 21.
22.
Replace the transmitter’s cover using four screws (F). See Figure 3 if necessary.
23.
Replace the transmitter’s access door using one screw (D). See Figure 3 if necessary.
9
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
