Simplex 300 - Setting the Time Table Program

Setting the Time Table Program
By setting the Time Table Program, automatic column shift and special mark "*" printing
can be set. This function is useful when columns need to be changed to print in/out time
without pushing a button or when a clear distinction for late in and early out is needed.
Example 1
<Automatic column shift>
To print the in time in Column 1 and the out time in Column 4
automatically.
(Work day ends at 17:00)
"Automatic column shift" and "Special mark printing" cannot be set
simultaneously.
Day advance time
Example 5:00
17:00
5:00
Next day
Print in Column 1 Print in Column 4
P1
The following is the time table based on the case above.
Program No.
P1
Time
1 7:00
Print column
COL. 4
• Times are always printed in Column 1 for the time period without program setting.
• One programmed day begins at the day advance time. See "Setting the Day Advance
Time" in this section for details.
• Up to 9 programs can be set (P1 through P9).
The time table program is explained using the following example.
23