EasyManua.ls Logo

SimPure Y6 - Filter Replacement Details; Replacement Filter Part Number; Feed Water Tank Cleaning; Tank Strainer and Sleeve Cleaning Instructions

SimPure Y6
11 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Filter Replacement Details
Replacement Filter Part Number
Part No.
Description
Replacement
Schedule
(Months)
HEDPF2001_S15
PP+CTO Filter Cartridge
6
HEDPF1001_S15
RO Membrane Cartridge
6
Note: Replace both cartridges as a pair (at the same time)
Feed Water Tank Cleaning
When replacing the filters (every six months) or sooner if required, check
the feed water tank strainers, check valves and feed water tank check
valves are both clean and free from obstructions
Tank Strainer and Sleeve Cleaning instructions
Remove the feed water tank and empty the water, located in the bottom of
the tank you will see the strainer and diversion sleeve, pull them both out.
Clean the parts under running water. Once clean, refit them and fill the
tank with clean water. Fit feed tank back into purifier ready for use.When
strainer filter blocks, it may takes longer for the water purifier to purify
feed water or the system does not work at all.
Troubleshooting Guide
Problem
Possible Solution
1
The Water purifier will
not turn on or respond
when pressing the
control panel dial
Plug the water purifier into the electrical outlet and
make sure the outlet switch is on (if applicable). The
purifier should beep once when connecting to the
power.
Plug the purifier into a different electrical outlet to
check the outlet is working.
2
All four indicators are on
at the same time
There is a system fault. Unplug the unit from the
electrical outlet for 5 minutes then reconnect. Contact
SimPure® customer service for advice if the problem
persists.
13
Strainer Filter
Diversion Sleeve
Check valve(Feed water tank base)
Check valve(feed water tank)

Related product manuals