4 | Preface
4.11 Connect the ground wire....................................................................... 34
5 Connect Simrad GB40 or Northstar 8000i .................................................. 35
5.1 Parts needed to connect radar to a GB40 or 8000i system........................... 35
5.2 Simrad GB40 using a SimNet heading sensor ............................................ 37
5.3 Northstar 8000i / Simrad GB 40 using a NMEA 0183 heading sensor............ 38
5.4 Radar system checklist........................................................................... 40
5.5 Setup the radar with the GB40 or 8000i.................................................... 40
6 Connect Simrad NX40 / NX45, Northstar M84 / M121 .............................. 43
6.1 Parts needed NX40/45 and M84/M121...................................................... 43
6.2 Simrad NX40/45 Northstar M84/M121 radar connections ............................ 44
6.3 Set up the radar with the Simrad NX40/45 or Northstar M84/M121 .............. 46
7 Connect Northstar 6000i / 6100i ............................................................... 47
7.1 Parts needed to connect to a Northstar 6000i / 6100i ................................. 47
7.2 Connect the radar processor to a 6000i or 6100i display ............................. 48
7.3 Connect the radar communications cable (NS003107) to the junction box ..... 49
7.4 Configure the remote power control for a 6000i or 6100i (common power
source) ............................................................................................... 51
7.5 Configure the remote power control for a 6000i or 6100i (different power
sources).............................................................................................. 52
7.6 Set up the radar with the Northstar 6000i or 6100i .................................... 54
7.7 Turn the radar on and off ....................................................................... 54
7.8 Configure the navigator communications .................................................. 55
7.9 Adjust the appearance settings ............................................................... 55
7.10 Heading sensor requirements ................................................................ 56
7.11 Disable the heading sensor input ........................................................... 56
7.12 Calibrating the radar ............................................................................ 56
7.13 Prepare for calibration .......................................................................... 56
7.14 Tune the radar .................................................................................... 57
7.15 Set the STC Curve ............................................................................... 57
7.16 Set the trigger delay ............................................................................ 57
7.17 Set the heading calibration (heading sensor installed)............................... 58
7.18 Set the heading calibration (heading sensor not installed) ......................... 59
7.19 Restore all the factory settings .............................................................. 59
7.20 Restore the factory appearance settings ................................................. 59
7.21 Manual tuning procedure for the 6000i or 6100i system ............................ 60
8 Maintenance .............................................................................................. 61
8.1 General maintenance ............................................................................. 61
8.2 Scanner maintenance ............................................................................ 61
8.3 Other maintenance items ....................................................................... 61
To Next Page
Loading...
Need help?
General
