Need help?Do you have a question about the Simrad Halo and is the answer not in the manual?
General| Networking | Ethernet |
|---|---|
| IP Rating | IPX6 |
| Range | Up to 72 nm (depending on model) |
| Operating Frequency | 9.4 GHz (X-band) |
| Frequency | X-Band |
| Display Compatibility | Simrad multifunction displays |
| Antenna Length | 24" or 20" |
| Supply Voltage | 10-32 V DC |
Copyright notice for the Halo Pulse Compression Radar Installation Manual.
Details regarding the warranty card and queries.
Statements on equipment intended use in international and coastal waters.
Details regarding CE compliance and R&TTE directive.
Important warnings and regulations from the FCC for device operation.
Crucial safety warnings and precautions for operating the radar system.
Check all components of the radar pedestal.
Verify all components of the radar antenna.
Confirm all parts of the RI-12 interface module.
Recommended safe distances for compass placement near the radar.
Guidelines for installing multiple radar systems on a vessel.
Specific installation considerations for power boats.
Advice for mounting the radar on a vessel's hard top.
Instructions for mounting the RI-12 interface module in a dry location.
Steps for securely mounting the radar pedestal to the vessel.
Connecting cables for surface mount installations.
Connecting cables for pole or tower mounts discreetly.
Procedure for attaching the radar antenna to the pedestal.
Details of the RI-12 interface module connections and ports.
Understanding the status indicated by the radar's LED lights.
Information on the pedestal interconnection cable and routing.
Steps for connecting the radar's DC power supply.
Ensuring proper grounding for system safety and performance.
Setting up remote control for the radar's power state.
Connecting the radar to the vessel's Ethernet network.
Connecting the radar to the NMEA 2000 network for data.
Connecting the radar via the NMEA 0183 interface.
Choosing the correct heading source for the RI-12 module.
Functionality and setup of the antenna park feature.
Selecting the radar source for setup via the display menu.
Navigating to the radar installation menu on the display.
Configuring the installed radar antenna length.
Setting the radar scanner's height above the waterline.
Aligning the radar's heading marker for accuracy.
Configuring sectors to avoid unwanted radar reflections.
Setting the antenna's standby position angle.
Reducing unwanted sidelobe interference for better clarity.
Viewing radar operational status, software, and serial number.
Restoring radar settings to factory default configuration.
Adjusting the pedestal's blue accent lighting levels.
Dimensional drawings of the RI-12 interface module.
Dimensional drawings of the radar pedestal and antennas.
Diagram illustrating the antenna's maximum rotation range.
Alternative mounting solutions from third-party vendors.
To Next Page
